10 Hardware-Accelerated Fast Power Measurement (Remote Command Only)
10.2 Reset Fast Power Measurement (Remote Command Only)
10.2.31 Channel x-dB Bandwidth Array
Example
:CALC:FPOW:POW1:DEF " XdBBandwidth =[-6.02, -3.01, -1.0]"
Notes Only applies to channels whose "Channel Measurement Function Array" on page 2842 is set to
XdBBandwidth. The X dB bandwidth parameter is used to specify the power relative to the peak
channel power over which the bandwidth is calculated. The parameter value must be a negative number
Preset [-3.01]
Range -200 to 0 dB
2844 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
