Keysight N9041B - Marker Trace; Marker Settings Diagram; 3.6.8 Meas Setup; 3.6.8.1 Settings

3 Spectrum Analyzer Mode
3.6 Power Stat CCDF Measurement
State Saved Saved in instrument state. Not affected by Marker Off and hence not affected by Preset or power cycle
Min 1
Max 12
Annunciation Appears in the marker label of a Delta marker
Marker Trace
Assigns the specified marker to the designated trace. The trace choices are:
–
MEASured
–
GAUSsian
–
REFerence
Remote
Command
:CALCulate:PSTatistic:MARKer[1]|2|…|12:TRACe MEASured | GAUSsian | REFerence
:CALCulate:PSTatistic:MARKer[1]|2|…|12:TRACe?
Example
:CALC:PST:MARK3:TRAC MEAS
:CALC:PST:MARK:TRACE?
Preset
MEASured
State Saved Yes
Range
MEASured|GAUSsian|REFerence
Marker Settings Diagram
Lets you configure the Marker system using a visual utility. This is the same as
"Marker Settings Diagram" on page 1203 in Settings.
3.6.8 Meas Setup
Contains functions for setting up the measurement parameters and also contains
functions for setting up parameters global to all measurements in the mode.
3.6.8.1 Settings
Contains frequently used functions to which you will want the fastest access.
Spectrum Analyzer Mode User's &Programmer's Reference 1205