7 Save/Recall/Print
7.3 Save
Suppose that, at the point where a Marker Table Meas Result is requested, the
following screen is showing:
Then the Meas Results file, when opened, would show the header data (the same as
for the Marker Table except that the Result Type is Peak Table) ending with a few
fields of specific interest to Peak Table users:
–
Peak Threshold
–
Peak Threshold State (On|Off)
–
Peak Excursion
–
Peak Excursion State (On|Off)
–
Display Line
–
Peak Readout (All|AboveDL|BelowDL)
–
Peak Sort (Freq|Amptd)
These fields are then followed by the data for the Peak Table itself.
Note that the label for the Frequency column changes to Time in 0 span.
2571 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
