7 Save/Recall/Print
7.3 Save
–
MechanicalAttenStepEnum
–
Periodic Timer Period
–
Periodic Timer Sync Source
–
Periodic Timer Trigger Delay
–
Periodic Timer Trigger Delay State
–
Preselector Adjust
–
Ref Trace
–
RFBurst Trigger Delay
–
RFBurst Trigger Delay State
–
RFBurst Trigger Level Abs
–
RFBurst Trigger Level Rel
–
RFBurst Trigger Level Type
–
RFBurst Trigger Slope
–
Scale/Div
–
Trigger Holdoff
–
Trigger Holdoff State
–
TriggerSource
The header section is followed by a line containing items MeasResult1 through
MeasResult4. This line forms a header for each set of measurement results, which
are listed in subsequent lines. Each line of Measurement Results consists of 4
comma-separated values, from the MeasResult1 value to the MeasResult4 value.
The MeasResult1 set in the file corresponds to the data returned by
MEAS|READ|FETCh:PSTatistic1; the MeasResult2 set corresponds to the data
returned by MEAS|READ|FETCh:PSTatistic2, and so on.
Meas Results File Example
When imported into Microsoft Excel or a similar spreadsheet application, a typical
Meas Results file appears as shown in the example below.
MeasResult
SA:PST
Spectrum Analyzer Mode User's &Programmer's Reference 2606
To Next Page