System Interconnects 4
TS-5020 Automotive Electronics Functional Test System Wiring Guide and Hardware Reference 4-21
High-Power Connector
A high-power (HP) connector can be added to the Test System
Interface. The 16-pin HP connector can route higher current
lines to the UUT. This is ideal for powering high-current devices
or for customizing the system for applications that require
higher power.
Connections to the High Power connectors are made using a
Positronic Industries PLC18F connector. Refer to Chapter 3 for
details on using this connector with the Keysight E6178B Heavy
Duty Load Card. A kit of parts, available from Keysight (E6244A
Opt. 020), provides the following:
• 20 Male contacts (Keysight 1252-8236) for shield-mounted
connector
• 20 Female Contacts (Keysight 1252-8235) for Keysight
1252-8234 connector housing
• Mating female connector housing (Keysight 1252-8234)
Figure 4-19 Connecting to High Power (HP) Connector
Do not exceed 60 VDC, 42VAC peak, or 30VAC rms or a maximum
15A on any pin of an HP connector.
To Next Page
Loading...
