2 Product Outlook
40 Keysight U1610/20A User’s Guide
To access the X or Y cursor functions.
To select and perform automatic measurements.
To select softkey functions and values.
To adjust the vertical sensitivity (gain) in voltage per vertical division (volt/div).
To adjust the waveform and ground level positions.
To access the horizontal modes.
To change the sweep speed in time per horizontal division (time/div).
To set the delay time (horizontal position).
Press and hold this key for:
– ≈3 seconds to turn on the handheld scope.
– ≈1 second to turn off the handheld scope.
– ≈10 seconds to power cycle the handheld scope.
During power-off battery charging, this key will show the following status:
– blinking red (capacity <60%)
– blinking yellow (60% < capacity < 90%)
– constant yellow (90% – 100% capacity)
During power-on battery charging, this key will always turn constant yellow. The
charging status is indicated on the top right of the display.
Key Description
To Next Page
Loading...
