3 Using the Oscilloscope
68 Keysight U1610/20A User’s Guide
Automatic Measurements
You can perform up to 30 automatic measurements (time, voltage, and power) on
any channel source or running math function.
To make a quick measurement:
1 Press to access the measurement function menu.
2 Press repeatedly to select a channel or math source. The math
source is applicable only when Analyzer Controls are enabled.
3 Press and use the keys to select a measurement type.
Press again to exit the selection menu.
4 Press to make the selected measurement.
Figure 3-9 Measurement function menu
Cursors are turned on to show the portion of the waveform being measured for the
most recently selected measurement.
If a portion of the waveform required for a measurement is not displayed or does
not display enough resolution to make the measurement, the result will be
displayed as no signal, no edges, greater than a value, or less than a value.
Last four
measurement
results
To Next Page
Loading...
