3 Using the Oscilloscope
60 Keysight U1610/20A User’s Guide
Level
See “Level” on page 55.
Baud rate
Press and press repeatedly to set the baud rate to match
the bus signal.
If the selected baud rate does not match the system baud rate, false triggers may
occur.
Sample point
Press and press repeatedly to set the sample point, which
represents the percentage of time between the beginning of the bit time to the
end of the bit time.
Standard
Press and toggle to select Standard CAN (2.0A) or
Extended CAN (2.0B).
Standard CAN has an 11-bit long identifier while Extended CAN has a 29-bit long
identifier.
Trigger
Press > to trigger on the SOF bit of a Data frame.
To Next Page
Loading...
