18
Getting Started with the Spectrum Analyzer Measurement Application
Accessories Available
Accessories Available
A number of accessories are available from Keysight Technologies to help you
configure your analyzer for your specific applications. They can be ordered through
your local Keysight Sales and Service Office and are listed below.
NOTE There are also some instrument options available that can improve your
measurements. Some options can only be ordered when you make your original
equipment purchase. But some are also available as kits that you can order and install
later. Order kits through your local Keysight Sales and Service Office.
For the latest information on Keysight signal analyzer options and upgrade kits, visit
the following Internet URL: http://www.keysight.com/find/sa_upgrades
50 ohm load
The Keysight 909 series of loads come in several models and options providing a
variety of frequency ranges and VSWRs. Also, they are available in either 50 ohm or
75 Ohm. Some examples include the:
909A: DC to 18 GHz
909C: DC to 2 GHz
909D: DC to 26.5 GHz
50 ohm/75 ohm minimum loss pad
The Keysight 11852B is a low VSWR minimum loss pad that allows you to make
measurements on 75 Ohm devices using an analyzer with a 50 Ohm input. It is
effective over a frequency range of dc to 2 GHz.
75 ohm matching transformer
The Keysight 11694A allows you to make measurements in 75 Ohm systems using
an analyzer with a 50 Ohm input. It is effective over a frequency range of 3 to
500 MHz.
AC probe
The Keysight 85024A high frequency probe performs in-circuit measurements
without adversely loading the circuit under test. The probe has an input capacitance
of 0.7 pF shunted by 1 megohm of resistance and operates over a frequency range of
300 kHz to 3 GHz. High probe sensitivity and low distortion levels allow
measurements to be made while taking advantage of the full dynamic range of the
signal analyzer.
To Next Page
Loading...
Need help?
General
