15
4
4
Features of your vehicle Keys
䳜 To cancel the sensor operation, go
to 'Settings → Convenience' and
turn Ultrasonic Intrusion Protec
-
tion to OFF.
䳜 If the system is armed when the
sensor is in the OFF status, the
intrusion/tilt sensor will not oper
-
ate.
Then, the alarm will be activated
when the system meets the
intrusion/tilt sensor off condition
of "Theft-alarm" stage.
To reactivate the sensor opera
-
tion, go to 'Settings → Conve
-
nience' and turn Ultrasonic
Intrusion Protection to ON again.
䳜 Do not activate the sensor if
there are any chances the vehicle
tilts by the outward influences
(for example, ferry boat
travelling, tower parking etc.),
because it could cause the siren to
sound inadvertently.
䳜 Make sure all windows are close
whilst the system operates. If
not, the sensor detects the inad
-
vertent movement inside the
vehicle (for example, blowing a
wind or entering a butterfly) and
it makes the siren sounds.
䳜 If boxes are piled high in the vehi
-
cle, the sensor may not detect
the movement behind the boxes.
Also the boxes may drop and it
makes the siren sounds.
䳜 If the sensor is stained with for
-
eign matter such as cosmetics,
spray type air freshener, or spray
type window cleaner, the sensor
may not operate normally.
Theft-alarm stage
The alarm will be activated if any of
the following occurs whilst the sys
-
tem is armed.
䳜 A door is opened without using
the remote key or smart key.
䳜 The tailgate is opened without
using the remote key or smart
key.
䳜 The engine bonnet is opened.
The horn will sound and the hazard
warning lights will blink continuously
for approximately 30 seconds. To
turn off the system, unlock the
doors with the remote key or smart
key.
Ultrasonic Intrusion Protection
(UIP) OFF condition
The alarm will be activated if any of
the following occurs whilst the sys
-
tem is armed.
䳜 A front or rear door is opened
without using the transmitter (or
smart key).
䳜 The tailgate is opened without
using the transmitter (or smart
key).
䳜 The bonnet is opened.