31
6
6
What to do in an emergency If you have a flat tyre (with tyre mobility kit)
9. Switch off the compressor.
10.Detach the sealant filing hoses
from the sealant bottle connector
and from the tyre valve. After
using, leave the sealant bottle and
the compressor attached
together.
Return the TMK to its storage loca
-
tion in the vehicle.
Carbon monoxide
Do not leave your vehicle running in
a poorly ventilated area for
extended periods of time. Carbon
monoxide poisoning and suffocation
can occur.
Distributing the sealant
䳜 Immediately drive approximately
7~10 km (4~6 miles or, about
10min) to evenly distribute the
sealant in the tyre.
Do not exceed a speed of 80 km/h
(50 mph). If possible, do not fall
below a speed of 20 km/h (12 mph).
Whilst driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road. Call for road side service or
towing.
When you use the Tyre Mobility Kit,
the wheel may be stained by seal
-
ant. Therefore, remove the wheel
stained by sealant and have the
vehicle inspected at a professional
workshop. Kia recommends to visit
an authorised Kia dealer/service
partner.
Checking the tyre inflation pressure
1. After driving approximately 7~10
km (4~6 miles or about 10 min),
stop at a safety location.
2. Connect the filling hose of the
compressor directly to the tyre
valve.
To Next Page
Loading...
