29
3
3
Safety features of your vehicle Seat belts
Stowing the rear seat belt
The rear seat belt buckles can be
stowed in the pocket between the
rear seatback and cushion when not
in use.
2nd row seat
3rd row seat
1. Route the seat belt webbing
through the rear seat belt guides.
It will help keep the belts from
being trapped behind or under the
seats.
2. After inserting the seat belt,
tighten the belt webbing by pull
-
ing it up.
When pulling out to wear the seat
belt, the tongue should be slowly
pulled out of the seat belt guide so
that the seat belt guide does not
come off the trim.
Releasing the seat belt:
䳜 The seat belt is released by
pressing the release button (1) on
the locking buckle.
When it is released, the belt
should automatically draw back
into the retractor.
If this does not happen, check the
belt to make sure it is not twisted,
then try again.
To Next Page
Loading...
