Kikusui PLZ1004W - Appendix; Operating Area of the PLZ-4 W

PLZ-4W Appendix A-1
Appendix
The appendices cover the operating area of the PLZ-4W, the basic operation modes
and sequence program creation table.
A.1 Operating Area of the PLZ-4W
As shown in Fig. A-1, the PLZ-4W can be used within the area enclosed by the con-
stant voltage line according to the rated voltage (L1), the constant power line accord-
ing to the rated power (L2), the constant current line according to the rated current
(L3), and the constant voltage line according to the minimum operating voltage (L4)
(operating area where specifications are guaranteed). For PLZ-4Ws with the mini-
mum operating voltage of 0 V, the specifications are guaranteed at input voltages at 0
V and greater. For 1.5 V input types, the specifications are guaranteed at input volt-
ages of 1.5 V and greater. If the current is decreased, these types can be used even at
voltages lower than 1.5 V (actual operating area). However, the specifications are not
guaranteed.
For the operating areas of each individual model, see appendix A.3, “Operating
Area of Each Model.”
Fig.A-1 Operating area
PLZ164W
(1.5 V input
type)
H range
PLZ164WA
(0 V input type)
H range
0.1
0.3
1
10
100
0.1 1 10
Input current [A]
Input voltage [V]
Operating area where
specifications are guaranteed
Actual operating area
165W
150
5
1.5
1.1
33
Log scale
L1
L2
L3
L4
0
0.5
0.3
1
010
Input current [A]
Input voltage [V]
Operating area where
specifications are
guaranteed
33
1.5
2.0
1.3
20
30
Actual operating area
L3
L4
Low voltage area
Low voltage area
<
1.5V
Log scale
0.1
0.3
1
10
100
0.1 1 10
Input current [A]
Input voltage [V]
Operating area where
specifications are guaranteed
165W
150
5
1.1
33
L1
L2
L3
L4
0
0.5
0.3
1
010
Input current [A]
Input voltage [V]
Operating area where
specifications are guaranteed
33
1.5
2.0
20
30
L3
Low voltage area