2-2
The UW, BC or UR has four leveling legs. If it
seems unsteady or you want the door to close
more easily, adjust the tilt using the instruc-
tions below.
Plug into a grounded 3 prong outlet.
Move the UW, BC or UR into its final loca-
tion.
Turn the leveling legs to the right to lower the
unit or turn the leveling legs to the left to raise
it. It may take several turns of the leveling
legs to adjust the tilt of the unit. NOTE: Hav-
ing someone push against the top of the unit
takes some weight off the leveling legs. This
makes it easier to adjust the leveling legs.
Open the door and check to make sure that
it closes as easily as you like. If not, tilt the
unit slightly more to the rear by turning both
front leveling screws to the right. It may take
several more turns, and you should turn both
leveling legs the same amount.
1.
2.
3.
4.
Remove the Packaging. Remove tape and
glue residue from surfaces before turning on
the unit. Rub a small amount of liquid dish
soap over the adhesive with your fingers.
Wipe with warm water and dry.
Do not use sharp instruments, rubbing alco-
hol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can
damage the surface of the unit.
Dispose of / recycle all packaging materials.
When Moving the Unit: The unit is heavy.
When moving the appliance for service, be
sure to protect the oor. Always pull the ap-
pliance straight out when moving it. Do not
wiggle or “walk” the appliance when trying to
move it, as oor damage could occur.
Clean Before Using: After you remove all of
the packaging materials, clean the inside of
the unit before using it.
•
•
•
•
•
UNPACK THE UNIT DOOR CLOSING
To Next Page
Loading...
