4-23
Remove the unit compartment cover (see
page 4-15)
Remove the two screws that secure the ther-
mostat to the unit in the unit compartment.
Use a small flat blade screwdriver to open
the two screw covers and remove the two
screws that secure the lower thermostat
bulb to the lower back wall of the inside of
the unit.
1.
2.
3.
Push the thermostat bulb back through the
hole in the unit.
When reassembling the unit, be sure to
replace the sealant that surrounds the
thermostat bulb in the unit compartment.
Disconnect the three wire connectors from
the thermostat.
4.
5.
6.
REMOVE AMBIENT THERMOSTAT (UW, BC)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Two Thermostat Screws
Sealant
Two Screw Covers
and Screws
Thermostat Bulb Hole
Three Wire Connectors
To Next Page
Loading...
