KLS Martin marLED E9 - Page 97

96 96 V. V. 1.01.0


Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
Recommend
Recommended separation distances ed separation distances between portable and between portable and mobilemobile
RF telecommunicatiRF telecommunications equipment and ons equipment and the KLS the KLS Martin marLEDMartin marLED
®®

according to IEC 60601-1-2 clause 6.8.3.201 b), Table according to IEC 60601-1-2 clause 6.8.3.201 b), Table 206206
The device is intended for use The device is intended for use in an electromagnetic environment in which radiated RF in an electromagnetic environment in which radiated RF disturbances aredisturbances are
controlled. The user can help prevent electromagnetic interference by maintaining a minimum distancecontrolled. The user can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF telecommunications equipment (transmitters) and the device asbetween portable and mobile RF telecommunications equipment (transmitters) and the device as
recommended below, depending on the maximum output recommended below, depending on the maximum output power of the power of the communications equipment.communications equipment.
Separation distance according to frequency of transmitter (in m)Separation distance according to frequency of transmitter (in m)
Rated maximumRated maximum
outputoutput PPofof
transmittertransmitter
in wattsin watts
150 kHz to 80 MHz150 kHz to 80 MHz
PPdd  3535..00== 
80 MHz to 800 MHz80 MHz to 800 MHz
PPdd  3535..00== 
800 MHz to 2,5 GHz800 MHz to 2,5 GHz
PPdd  7070..00== 
0,01 0,01 0,04 0,04 0,04 0,04 0,080,08
0,1 0,1 0,11 0,11 0,11 0,11 0,220,22
1 1 0,35 0,35 0,35 0,35 0,700,70
10 10 1,11 1,11 1,11 1,11 2,212,21
100 100 3,50 3,50 3,50 3,50 7,07,0
For transmitters rated at a For transmitters rated at a maximum output power not listed above, the recommended separationmaximum output power not listed above, the recommended separation
distancedistance ddin meters (m) can in meters (m) can be estimated using the equation applicable to the be estimated using the equation applicable to the frequency of thefrequency of the
transmitter, wheretransmitter, where PPis the maximum output power rating is the maximum output power rating of the transmitter in watts of the transmitter in watts (W) according to(W) according to
the transmitter manufacturer.the transmitter manufacturer.
Note 1:Note 1:

At 80 MHz and 800 MHz, the At 80 MHz and 800 MHz, the separation distance for the higher frequency rangeseparation distance for the higher frequency range
applies.applies.
Note 2:Note 2:
These guidelines may not apply in all These guidelines may not apply in all situations. Electromagnetic propagsituations. Electromagnetic propagation isation is
affected by absorption and reflection from structures, objects and people.affected by absorption and reflection from structures, objects and people.