Section 1
Introduction
20425553
5-2005/Rev 0
1-5
3. Close, lockout and tag the manual shutoff valves for all service connections: cutting water
in, cooling water in and out, and air.
Warning Labels
Warning labels are posted on the machine to indicate potential hazards. The operator and service
personnel shall pay particular attention to these warning labels. Table 1-2 describes the necessary
precautions and provides the part number required to order replacement labels.
Table 1-2
Warning Label Precautions
1
P/N 05114962
The electric motor and optional junction box can
present an electrical shock hazard. Always disconnect
and lockout the main power before performing any type
of maintenance.
2
P/N 05114970
The surface of high pressure water and hydraulic
components becomes hot during normal operation.
Failed, or failing components, can become extremely
hot during operation.
3
P/N 05098017
High pressure water and/or hydraulic pressure can
remain in the system even when the pump has been shut
off. All pressure can be safely bled from the system by
opening the high pressure cutting water valve for a few
seconds after shutting off the pump.
To Next Page
Loading...
Need help?
General
