Section 2
Installation
20425561
5-2005/Rev 0
2-3
Transporting
The weight of the machine is not evenly distributed from one end to the other. Note the warnings
stamped on the crate. The center of gravity is clearly identified on the sides of the crate. The
forklift should be positioned accordingly.
When the machine has been removed from the crate, note the position of the fork pockets on the
bottom of the machine. The pockets are positioned in relationship to the center of gravity to
balance the weight on the forklift.
Figure 2-2: Fork Pockets
The machine must be lifted from the bottom. Do not attempt to lift the machine
from the intensifier.
2.4 Power Requirements
Power supplied to the pump and wiring for remote control must comply with local, regional and
national electrical codes. Service voltage and ampacity must meet the requirements detailed in
Table 2-2. Voltage fluctuations in excess of +/- 10 percent of nominal voltage may damage the
machine and void the warranty.
To Next Page
Loading...
Need help?
General
