KMT STREAMLINE S30 - Page 71

Section 7
Electrical System
20425610
5-2005/Rev 0
7-7
4. Install a new proximity switch by positioning the o-ring spacer and the switch. Ensure the
o-ring is correctly oriented.
5. Apply JL-M grease to the threads on the screws and tighten to 140-160 in-lbs (16-18 Nm).
Ensure that the proximity switch is properly installed and secured prior to starting
the machine. Failure to tighten the two hold down screws will result in the spray
of hydraulic oil.