SECTION 2
INSTALLATION
Page 2-2
49831894
2.1.1 Buyer Obligations
Equipment installation requires cooperation between the user and KMT
Waterjet. If on-site support is requested, the KMT Waterjet Service Department
will require the following tasks be accomplished before arrival at the customer
site.
• The waterjet cutting equipment should be uncrated, positioned and leveled,
with electrical and fluid services brought to the unit.
• Provide and install power drops with fused disconnects sized to the
equipment power requirements.
• Provide and install pneumatic drops with manual shutoff valves.
• Provide all mounting and support brackets and hardware for high pressure
tubing runs.
• Provide and install water conditioning equipment necessary to meet water
purity requirements. Provide and install manual shutoff valves.
• Provide and install necessary cooling water inlet/outlet, and drain water
connections to the intensifier pump, and/or cutting equipment and manual
shut-off valves.
• Provide suitably located and sized drains and proper disposal of waste
water.
• Provide, install and connect wiring between the intensifier pumps, and the
cutting station control system.
• KMT Waterjet supplies a pre-filled hydraulic system. If fluid is low or empty
due to leakage during transit, the system must be filled per specifications.
To Next Page
Loading...
Need help?
General
