A-61837 September 2016 11
Turning the scanner
on
• Press the Power button.
When you turn on the scanner, the input elevator will open if it is not already
opened and the green indicator on the Start/Pause button will flash as the
scanner goes through a series of self tests.
The scanner takes less than 20 seconds to complete the power-up sequence
and be ready to scan. When the installation process is complete and ready to
scan, the green LED on the Start/Pause button will stop flashing and remain
constant and the Ready screen will be displayed.
Standalone mode The i4x50 Scanners can be used in standalone mode and can be powered on
without connecting to a host PC. When the scanner is in standalone mode, the
following functions are available in Diagnostics mode:
• Count only
• Count only with multi-feed
• UDDS calibration
•Print test
• Patch test
To Next Page
Loading...
