A-61837 September 2016 55
Cleaning the separation roller
tires
5. Pull the separation pad holder forward and remove the separation roller.
NOTE: The separation roller cover is spring-loaded. Hold the separation
roller cover back until you remove the separation roller, then
gently lower the roller cover back in place.
6. Manually rotate and wipe the separation roller tires with a roller cleaning
pad. For best results wipe parallel to the ribs in order to remove any
residue between the ribs.
7. Inspect the tires. If the tires show signs of wear or damage, replace the
separation tires. See “Replacement procedures” later in this chapter.
8. Reinstall the separation roller by aligning the slots on the separation roller
with the holders.
To Next Page
Loading...
