A-61837 September 2016 65
To replace the tires:
6. Replace each tire by sliding the tire off the core.
7. Install each new tire by gently pulling it over the core.
IMPORTANT:Do not overstretch the tire; it may tear.
8. Reinstall the separation roller. Be sure to line up the slots on the separation
roller with the holders.
9. Gently lower the roller cover back in place.
10. Close the scanner cover.
Replacing the pre-
separation pad
Change the pre-separation pad when the frequency of multifed documents
increases.
1. Power down the scanner.
2. Open the scanner cover.
3. Remove the pre-separation pad by lifting the pad up and out of position.
NOTE: The pre-separation pad fits snuggly in place; therefore, a little
force may be required to remove it.
4. Install the new pre-separation pad. Be sure it snaps into place.
5. Close the scanner cover.
To Next Page
Loading...
