18 A-61837 September 2016
Adjusting the output tray
for lead edge alignment
and normal document
handling
The Kodak Lead Edge Alignment Exit Tray Accessory is available if you want
the edges of your documents to align against the output tray document stop
after scanning. For more information about using this exit tray, see the
instructions that came with this accessory.
Using the rear document
exit
Documents that require special handling (e.g., fragile documents, shipping
envelopes, etc.) can be output using the rear document exit. This exit provides
the straight-through paper path option that allows an exception document(s) to
pass straight through the transport, thus reducing the possibility of a document
jam.
Use the rear document exit when:
• documents are too stiff (e.g., rigid) to make the turn in the transport and are
jamming.
• documents are fragile and you do not want to bend them.
• output stacking order is not important.
• scanning directly into the recycle bin when documents are no longer needed
after scanning.
• scanning photographs.
NOTES:
• Be sure to toggle the rear document exit switch back into its original position
when finished.
• Be sure that you have adequate clearance behind the scanner to feed the
document(s) through when using this option.
• When scanning several documents through the rear document exit, the
documents will be output in the reverse scanning order.
To Next Page
Loading...
