56 A-61837 September 2016
Cleaning the feed module
tires
9. Clean the feed module tires by manually rotating and wiping the feed
module tires with a roller cleaning pad. For best results wipe parallel to
the ribs in order to remove any residue between the ribs. You do not need
to remove the feed module to clean the tires.
NOTE: Do not use Staticide wipes or Brillianize Detailer wipes to clean
the feed module tires.
10. Inspect the tires. If the tires show signs of wear or damage, replace the
feed module tires. See “Replacement procedures” later in this chapter.
Cleaning the Flippable
White background strips
1. Power down the scanner.
2. Open the scanner cover.
3. Wipe the upper and lower background strips with a Staticide wipe or a
“Step 1” Brillianize Detailer wipe
NOTE: Be careful not to touch the transport rollers.
4. Wipe the upper and lower background strips again with an almost-dry
Staticide wipe or a “Step 2” Brillianize Detailer wipe to remove any streaks.
To Next Page
Loading...
