30 A-61837 September 2016
Performing a UDDS
calibration
UDDS calibration is used to calibrate the ultrasonic document detection
system for multifeeds. UDDS calibration is rarely needed. This calibration
should only be performed if there is a feeding or multifeed detection issue.
1. Select UDDS Calibration. The UDDS Calibration screen will be displayed.
2. You will be prompted to place an A4 size 75-80 g/m
2
or lettersize 20 lb.
bond sheet of paper in the input elevator in portrait orientation.
3. Press the Start/Pause button. The calibration results will be displayed.
Alterations This option is for Service Use only. Only use this option when directed to do so
by Kodak Alaris Service personnel.
To Next Page
Loading...
