12 A-61837 September 2016
Turning the scanner
off
• Press the Power button for one second.
• If the scanner has a critical error, you can press and hold the Power button
for 5 seconds to turn the scanner off.
Power modes The following chart provides information regarding the power modes of the
scanner, LED status and the manual or automatic action that will put the
scanner into a given power mode.
* Consult with Kodak Alaris Service personnel for custom options.
Mode Operator Control Panel
LED
Power Consumption
Standby
(Off)
Off < 0.5 watt
Sleep
(Low Power)
Flashing green
once every 2.5 seconds
< 1.5 watts
Ready
(Not Scanning)
On (green) < 55 watts
Scanning On (green) < 130 watts
Ready
(No Host)
On (red) < 55 watts
Mode Transition Manual Action Automatic Action
Standby to
Ready
Tap the Power button None
Ready to
Standby
Press and hold the Power
button for 1 second
None
Ready to Sleep None
Programmable time delay:
1 to 240 seconds
Factory default: 15 minutes
Sleep to Standby
Press and hold the Power
button for 1 second
Programmable time delay:
0 to 240 seconds
Factory default: 60 minutes*
Sleep to Ready
Any of the following:
• Tap the Power button
• Tap any Operator Control
Panel button
• Place paper in the input
elevator
• Receiving a host
command
None
To Next Page
Loading...
