62 A-61837 September 2016
Replacing the feed module
tires
4. If you are replacing the entire feed module, go to Step 11. If you are
replacing the tires, proceed with Step 5.
5. With one hand, press the locking tabs (one on each side) while holding the
lower housing with the other hand. Pull the upper housing up and away
from the rollers.
6. Remove both core assemblies.
7. Replace each tire by sliding the tire off the core.
8. Install each new tire by gently pulling it over the core. The tires do not need
to be installed in any specific orientation. Make sure that the tires are fully
aligned with the flange edge. If they are improperly aligned, premature
wear of the tires may occur.
IMPORTANT:Do not overstretch the tire; it may tear.
To Next Page
Loading...
