A-61837 September 2016 45
6. Slide the printer carrier into the desired print position. See the section
entitled, “Changing print positions” later in this chapter for more
information.
7. Close the printer access cover and reinstall the output tray.
8. Run a print test (see the next section).
Running a print test You can run a print test by using the Print Test option on the Operator Control
Panel (see Chapter 3, “Performing a print test”) or you can use the Scan
Validation Tool.
1. Place a blank sheet of paper in the input elevator.
2. Ensure that the ink cartridge is properly installed.
3. Select Start>Programs>Kodak>Document Imaging>i4x50.
4. Select TWAIN for the Driver Type and the KODAK Scanner: i4x50. The
Scan Validation Tool dialog box will be displayed.
To Next Page
Loading...
