L05026 Steering Component Repair L5-31
45. Install O-rings (26, 27 and 28) in proper location
on top of valve plate. Install compensator (13)
to valve plate with capscrews (9) and tighten
securely.
46. Install 4-way valve (8), and relief valve (14).
47. Install 0.062 in. (1.575 mm) diameter orifice (30)
and plug (7) with new O-ring (6) in side of com-
pensator block as shown in Figure 5-25. Install
0.032 in. (0.813 mm) diameter orifice (10), plug
(7) and O-ring (6) in top of block.
10. Install remaining plugs with new O-rings.
11. Install unloader module (29) on compensator
block with new O-rings (25) and socket head
capscrews (31). Tighten capscrews to 87 in.
lbs. (9.8 N.m) torque.
12. Install plugs (9 & 23, Figure 5-23) and O-rings
(10 & 15) in pump housing.
13. Measure pump rotation torque. Rotation torque
should be approximately 15 ft. lbs. (20.4 N.m).
To Next Page
Loading...
