E02016 2/02 Electrical Propulsion Components E2-43
Download Configuration Files
Download configuration files into the CPU on the truck
as follows:
1. From the GE STATEX III PTU MAIN MENU (Fig-
ure 2-19) use the arrow keys to move the cursor
to the “SPECIAL OPERATION WITH ENGINE
STOPPED” selection and press [ENTER]. An
intermediate screen will appear asking yes or no.
With the cursor on “yes” press [ENTER]. The
SPECIAL CONTROL ENGINE STOPPED TEST
MENU screen appears.
2. Use the arrow keys to move the cursor to the
VIEW PROGRAM TRUCK FILE selection and
press [ENTER]. The screen will show the CFG
and OBJ file to be downloaded.
3. Press [ESC] to return to the previous menu.
4. Use the arrow keys to move the cursor to the
“program truck yes/no menu” selection and press
[ENTER]. The PROGRAM TRUCK YES/NO
MENU screen appears.
5. Use the arrow keys to move the cursor to desired
program truck selection.
a. “NO, Return to Engine Stopped Test
Menu”This selection will take the computer
back to the SPECIAL CONTROL ENGINE
STOPPED TEST MENU.If, for some reason
programming is not desired, select this choice.
b. “YES, RELOAD PROGRAM INTO TRUCK”
Use whenever the truck CPU has already
been programmed and re-programming is
desired. This selection is appropriate if, for
example, the truck configuration file has been
modified. The configuration file must be
reloaded for the changes to become effective.
c. YES, INSTALL PROGRAM INTO TRUCKUse
to install a program into the truck CPU for the
first time or into a new or modified FB101
card. For example, if the FB101/144 card
EPROM's are updated.
6. Press [ENTER] to begin programming the truck.
The programming will take approximately 15 min-
utes to complete.
7. During the downloading operation, various mes-
sages are displayed on the PTU screen as the
procedure progresses. At completion, press
[SPACE] per instruction on the screen.
To Next Page
Loading...
