WIGGINS QUICK FILL FUEL SYSTEM
FUEL RECEIVER
The fuel receiver (3, Figure 5-1) is normally mounted
on the fuel tank (1). Optional locations are the left hand
frame rail (Figure 5-3) or at the Service Center in front.
Keep the cap on the receiver to prevent dirt build up in
valve area and nozzle grooves. If fuel spills from tank
breather valve, or tank does not completely fill, check
breather valve to see that float balls are in place and
outlet screen is clean. If valve is operating properly, the
problem will be with the fuel supply system.
FIGURE 5-1. FUEL TANK BREATHER & RECEIVER INSTALLATION
1. Fuel Tank
2. Breather Valve
3. Fuel Receiver
4. Fuel Level Gauge
NOTE: This Illustration Represents a Typical Installation.
Fuel tank may vary in size, shape and location depending on truck model.
M05002 10/96 Wiggins Quick Fill Fuel System M5-1
To Next Page
Loading...
