Installation CP3002
Page 3 - 8 ID 1042-9252, Rev. 2.0
P R E L I M I N A R Y
12. Connect all required interfacing cables to the board.
Replacement of the CP3002 under power is now complete.
Warning!
The CP3002 front panel cables and, when installed, the RIO transition
module front panel cables may have power applied which comes from an
external source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
To Next Page
Loading...
