Kontron CP3002 - General Purpose Output Register (GPOUT)

Configuration CP3002
Page 4 - 18 ID 1042-9252, Rev. 2.0
P R E L I M I N A R Y
4.3.16 General Purpose Output Register (GPOUT)
The General Purpose Output Register holds the general purpose output signals of the rear I/O
CompactPCI connector J2. This register can be used only if the CP3002 is ordered as a rear I/
O version and the rear I/O GPIO operation is configured through the dedicated rear I/O module
configuration signal on the CompactPCI J2 connector.
Table 4-18: General Purpose Output Register (GPOUT)
REGISTER NAME GENERAL PURPOSE OUTPUT REGISTER (GPOUT)
ADDRESS 0x292
BIT NAME DESCRIPTION
RESET
VALUE
ACCESS
7 - 3 Res. Reserved 00000 R
2 GPO2 General purpose output 2 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W
1 GPO1 General purpose output 1 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W
0 GPO0 General purpose output 0 signal (3.3V LVTTL):
0 = Output low
1 = Output high
0R/W