Korg C1 - Assembling the Stand; Warning: Assistance Required; Caution During Assembly; Other Cautions

17
3. Insert the pedal unit into the pedal board, and then fas-
ten it by pressing a push rivet into the hole (above the
cutout) at the rear of the pedal board.
Afterpressingitintothere,liftthepedalboardtocheck
thatthepedalsdonotdrop.Thepedalmauntingpinwill
preventthepedalunitfromfallingout.Therefore,itcannot
befullyfastenedtothepedalboard.
4. Using four screws (M4), temporarily fasten the pedal
board (with the pedal unit aached) to the brackets at
the boom of the inside of the left and right side panels.
*Totemporarilytightenthescrewsistotightenthemleav-
ing
aclearanceofabout2mm.
Side panel (right)
Side panel (left)
Screws
(M4)
Screws (M4)
5. Lift up the speaker box so that the brackets (A) on the
left and right side panels pass through the dents in the
speaker box. When the brackets (A) are fully hidden
within the speaker box, push the speaker box forward so
the rear of the speaker box is nearly ush with the edges
of the side panels. Then, the speaker box can be released.
 Becarefulnottopinchyourngers.
Locking
tab
Front
Push
Front of pedal board
Rear
Push rivet
Rear of pedal board
Assembling the Stand
Warning
● At least one other person must help you assem-
ble the stand.
Caution during assembly
• Makesurethatyouhavethecorrectpartinthecorrectori-
entation,andperformtheassemblyintheordergiven.
Other cautions
• Loosened screws
Thescrewsmayloosenastimepassesafterassembly.You
shouldperiodicallycheckwhetheranyscrewshavebecome
loose.Ifyoufeelthatthestandvibratesexcessively,itispos-
siblethatscrewshavecomeloose.Ifso,re-tightenthem.
• When moving the digital piano to another location
Tomovetheassembledstand,removetheACadaptercord
fromthestand,closethekeycover,andthenmoveitslowly
withatleasttwopeoplekeepingitaslevelaspossible.
• Disassembly
Ifyouneedtodisassemblethestand,dosobyreversingthe
stepsoftheassemblyprocedure.Afterdisassembly,keepthe
screwsandotherpartsinasafeplacesothattheyarenotlost.
Assembly procedure
You’llneedaPhillips(+)screwdriver.
1. Make sure that all of the following parts are available.
Anti-tipping Bracket
(left)
Anti-tipping Bracket
(right)
Pedal unit
Pedal board
Speaker box
Side panel (right)
Side panel (left)
Pedal cord
Screws
(M6)
x 2 pcs.
Screws (M4)
x 12 pcs.
Push rivet x 1 pc.
Cord holder
x 1 pc.
Stabilizing felt x 4 pcs.
2. Connect the aached pedal cord, observing the correct
orientation, to the connector on the reverse side of the
pedal unit, and then engage it with a slot in the pedal
unit.
The pedal cord can be aached to or detached from the
connectorwithitslockingtabhelddown.