Selecting and Playing Sounds
6
If you select a sound using the display, buttons 1-16 will go dark. To return to the Set List, just press one of the buttons
again.
You can store many different Set Lists, and switch between them as desired. To select a different Set List:
1. Press UTILITY twice, to go to the System Setup page.
2. Select the Set List parameter, and press ENTER or turn the VALUE knob.
From this point, selecting Set Lists works just like selecting Performances, as described above.
Assigning a Performance to a Set List Slot
1. Select the Performance that you’d like to assign.
2. Press the SET LIST button, so that it is lit.
3. Hold WRITE and press the Slot to which you’d like to save.
The Write page appears, with that Slot already selected. To change the Slot, hold WRITE and press a different Slot
button.
4. Press WRITE, and then ENTER to confirm.
The Set List will also be saved. If the Performance has been edited, you’ll be prompted to save it too.
Assigning to a Slot in a different bank
While you’re on the Write page, you can also select a Slot from a different bank (for instance, if you’re copying a
Performance to a different Slot):
1. Hold WRITE and SHIFT (or, if you prefer, WRITE and SET LIST), and press button 1-4 for the desired Bank.
2. Release WRITE and SHIFT.
3. Proceed to Step 3 above.
To Next Page
Loading...
Need help?
General
