Filter
53
2-Pole LP/HP/BP/BR
(Resonance) Bass
[Full, Tight]
This is available only when Type is one of the 2-pole Resonant or 4-pole Resonant settings, or Multi Filter. Resonance
Bass controls the character of the filter resonance at low cutoff frequencies. Its effect is most noticeable with high
Resonance settings.
Tight produces a more restrained resonance, similar to a classic, American, wood-paneled monophonic synthesizer.
Full produces a wide, boomy resonance, reminiscent of a famous five-voice American synthesizer.
4-Pole LP/HP/BP/BR
Resonance Type
[Standard, High]
Resonance Type is available only when using one of the 4-pole filters.
Standard provides the resonance character of a typical analog 4-pole filter.
High creates a more pronounced resonance.
MS-20 LP/HP and Polysix
Gain
[Loud, Less Resonance; Unity, Less Resonance; Normal, 1-osc input; Normal, 2-osc input]
Gain is available only when Type is MS-20 LP, MS-20 HP, or Polysix. These filter types include saturation, which
interacts with resonance. With anything other than very low resonance settings, input volume can have a strong effect
on their character. The lower the input gain, the more headroom remains for the resonance to bloom. Use Gain to set
the basic input level, and then fine-tune with Trim if desired.
To Next Page
Loading...
