Motion Sequencing 2.0
37
Timing Lane Step
Tempo On
Tempo Off
Step
[A1…D16]
This is the current Step. You can edit this parameter on-screen, or use the SEQ STEP buttons to select Steps directly.
Type
[Note, Rest, Gate]
Note: The step will play normally.
Rest: The step will be silent.
Gate: The sequence will pause at the step until note-off, after which the sequence continues. If this is also the End Step,
the Motion Sequence will stay on the step through note-off. By setting a single Timing Step to Gate, and then
modulating the Lane Start Step by velocity, you can create a sound with up to 64 velocity switches. For instance, you
can use this to switch between a large number of different Shapes.
Duration
[TEMPO Off: 0.0000…10.0000 seconds]
[TEMPO On: List of rhythmic values]
If TEMPO is Off, you can set the length of the step in seconds.
If TEMPO is On, you can set the basic length of the step as a rhythmic value, relative to the system tempo. The values
range from a 32nd note to a double breve (four whole notes), including dotted notes and triplets. This length is then
modified by x (Multiply Base Note by…), below.
x (Multiply Base Note by…)
[1…32]
This appears only if TEMPO is On. It multiplies the length of the Duration Base Note. For instance, if the Base Note
is set to an eighth note, and Times is set to 3, the step will last for a dotted quarter-note.
Probability
See “Step Probability” on page 35.
To Next Page
Loading...
