Pitch
59
Pitch
Osc Pitch
Osc 1
Osc 1 Octave (SHIFT-POSITION)
[–2…0…+2]
This sets Oscillator 1’s basic pitch, in octaves. The default is 0.
Tune (SHIFT-A/B BLEND)
[–12.00…+12.00]
This adjusts Oscillator 1’s pitch in increments of 1/100 of a semitone, over a range of ±1 octave.
Osc 1 Transpose
[–12…+12]
This adjusts Oscillator 1’s pitch in semitones, over a range of ±1 octave. When the Oscillator is set to Sample, this also
affects the index into the Multisample map, potentially changing the sample selection—similar to transposing the
entire keyboard.
Sub Octave
[–2, –1, 0]
This applies only when Sub/Noise Type (on the Mixer & Sub Osc page) is set to Square or Triangle. It sets the pitch
offset from Oscillator 1, in octaves. The default is -1. This parameter is duplicated on the Mixer & Sub Osc page.
Osc 2
Osc 2 Octave (SHIFT-POSITION)
[–2…0…+2]
Tune (SHIFT-A/B BLEND)
[–12.00…+12.00]
Osc 2 Transpose
[–12…+12]
See the descriptions for Osc 1, above.
To Next Page
Loading...
