Amp
62
Amp
Amp
Press AMP to go to this page.
Notes on Amp Modulation
Amp modulation scales the Amp Level and Amp Envelope. The final volume is determined by multiplying these by
any additional modulation sources, with an upper limit of 2x the original level. If the original level is low, the
maximum modulated volume will also be low.
Tip: To start with a low level (or silence) and then use modulation to raise the level to maximum, use the Filter Output
Level instead.
Level
[0%…100%]
This sets the basic volume of the Program, optimized for per-voice modulation. For adjusting the volumes of Programs
within a Performance, it’s better to use Layer Volume instead.
Amp LFO (INTENSITY)
[–100%…+100%]
This controls the amount of modulation from the Amp LFO.
Velocity (VELOCITY)
[–100%…+100%]
With positive (+) values, the volume increases as you play harder.
With negative (–) values, the volume decreases as you play harder.
To Next Page
Loading...
