Utility
90
Utility
System Setup
Set List
[List of Set Lists]
This selects the current Set List, which maps Performances to the SET LIST buttons. You can store many Set Lists, and
change between them as you like.
Octave (OCTAVE -/+)
[-4…+4]
This shifts the keyboard up or down by up to four octaves. It’s generally controlled by the front panel OCTAVE
buttons, although these can optionally control scale selection, instead; see “Octave Selects Scale” on page 95. When
controlling Octave, the OCTAVE buttons change color according to the degree of transposition:
Transpose
[–12…+12 semitones]
This adjusts the pitch in semitone steps over a ±1 octave range.
Note: Transpose is affected by the Convert Position setting; see “Convert Position” on page 92.
Tune
[–50 (427.47Hz)…+50 (452.89Hz)]
This adjusts the overall tuning of the entire modwave in one-cent units, over a range of ±50 cents. (A cent is 1/100 of a
semitone.) At the default of 0, A4 = 440 Hz.
The value shown for A4’s frequency assumes that the scale is set to Equal Temperament. If a different scale is
selected, the actual frequency of A4 may be different.
System ID
This number identifies the modwave to computer hosts. If you have multiple modwaves, set each to a different
number.
Octave Color
-1/+1 Green
-2/+2 Yellow
-3/+3 Orange
-4/+4 Red
To Next Page
Loading...
