Wavetable Osc
25
Speckled Noise: This is noise with both roll-off and clipping, producing a very aggressive timbre. With additional
lowpass filtering, it can produce sounds reminiscent of thunder and explosions.
Saturated Noise: This uses moderate filtering and saturation to produce a thicker-sounding noise signal.
Oct
[–2, –1, 0]
This applies only when Sub/Noise Type (on the Mixer & Sub Osc page) is set to Square or Triangle. It sets the pitch
offset from Oscillator 1, in octaves. This parameter is duplicated on the Osc Pitch page. Set Octave to -1 or -2 to add
rumbling bass, or to 0 to supplement the fundamental of a thin-sounding Wavetable.
Level (LEVEL)
[0%…100%]
This sets the volume of the Sub/Noise component.
Pan
[L100…L1, C0, R1…R100]
This sets the stereo position of the Sub/Noise component.
To Next Page
Loading...
