Modulation
66
Filtering the modulation list
The list of modulations can be long. To view only the modulation routings related to a specific controller or section of
the synth, use the Show parameter on the Modulation List Info page. As a shortcut to open this parameter's popup
from anywhere in the UI, hold MOD and press <, as described below:
1. Hold MOD and press <.
The Show In Mod List dialog appears.
2. Press AMP, PITCH, FILTER TYPE, WAVE SELECT, or an Envelope, LFO, or Effect button; press a Lane but-
ton (pressing SHIFT is not required for Lane selection here); move a MOD KNOB; hold ENTER and move a
controller or play a note on the keyboard (for Velocity); or send a MIDI message. Use the on-screen list for
other selections, such as Key Track or Mod Processors.
Note: moving a knob in this popup will not edit the knob’s parameter.
3. Press ENTER to confirm, close the popup, and return to the Mods page. Alternatively, to exit without making
a change, hold SHIFT and press ENTER.
The Show setting is included in the top line of the display: ALL, FILTER, SHAPE LANE, etc. The list will be filtered to
show only the matching items—notice how much bigger the scroll-bar thumb is in the filtered list below, indicating
that there are only a few items in the list.
To clear the Show setting and show all modulations:
1. Press MOD in the Show In Mod List dialog, or set Show to All.
Deleting a modulation routing
To delete the currently shown modulation routing:
1. Hold SHIFT and press MOD.
A confirmation message will appear, asking if you want to delete the modulation routing.
2. Press ENTER to confirm, or any other key to cancel.
To Next Page
Loading...
