Arp & Setup page
49
Trigger
Latch
[O, On]
O: e Arpeggiator will only play as long as notes are being held on the keyboard (or via the damper pedal).
On: e Arpeggiator will continue to play aer notes are released.
Sync Notes
[O, On]
O: e arpeggiator starts immediately when the rst note is played, and does not synchronize to any Motion
Sequences or itself when latched. You could use this if you were playing with a human drummer and needed to reset the
arpeggiator rhythm to the drummer's beat periodically.
On: e arpeggiator will synchronize to either sounding Motion Sequences or itself when latched. When synchronizing
to Motion Sequences, the rst note will sound when played, but subsequent arpeggiator-generated notes will be in sync
with the Motion Sequence. When playing a latched arpeggiator, new notes will sound when the arpeggiator beat comes
around; the arpeggiator's rhythm is not disturbed by playing new notes.
Layer Setup
Volume
[-Inf, -84.9…+6.0 dB]
is controls the volume of the Layer. Note that this is saved in the Performance, but not with the Program—so it’s a
good choice when balancing levels between Layers.
Pitch
ese parameters control the octave and tuning of the Layer. As with Layer volume, this is saved in the Performance,
but not with the Program—so it’s a good choice when creating detuning or octave osets between Layers, without
making the Program play out of tune if it’s saved and selected elsewhere!
Octave
[-3…+3]
is transposes the Layer by 3 octaves, up or down.
Tune
[-100…+100 cents]
is lets you detune the Layer by up to 100 cents (1/100 of a semitone), up or down.
MIDI
Use Global MIDI Channel
[O, On]
On: is is the default. e Layer will receive on the Global Channel.
O: e Layer will receive on the channel specied below.
MIDI Channel
[1…16]
is is shown only if Use Global MIDI Channel is O. It sets the channel on which the Layer will receive MIDI.
Rx Damper
[O, On]
On: is is the default. e Layer will respond to MIDI CC#64.
O: e Layer will ignore MIDI CC#64.