Motion Sequencing 2.0
44
is applies only if the Pitch Lane Transition parameter is set to Individual.
O: Pitch will change abruptly at each step. is is the default.
Lin: e pitch will glide linearly from step to step.
Exp: e pitch will glide from step to step, with most of the change at the end of the glide.
Log: e pitch will glide from step to step, with most of the change at the start of the glide.
Probability
See “Step Probability” on page 40.
Shape
e Shape Lane creates a contour over the duration of the step. It can aect the Pitch Lane and/or any of the Seq Lanes
(when the respective Lane’s Use Shape is On).
Shape Lane
Preset, Loop Start, Loop End, Loop Mode, Repeats, Note Advance
See “Standard Lane Controls” on page 39.
Shape Lane Step
Shape
[List of shapes]
ere are a large number of shapes to choose from, including ones with two, three, or four pulses.
Oset
[-1.00…+1.00]
is shis the entire shape up or down. It works slightly dierently from Mod Processor “Oset,” in that the Oset is
added to the shape, and then the result is scaled by the Level, below. For instance, if you want Shape to control volume,
but don’t want the volume to drop all the way to silence, set Oset to +1.00 and Level to +0.50.
Level
[-2.00…+2.00]
is varies the amplitude of the Shape. Negative values invert the shape.
Phase
[-180…+180°]
is controls the start point of the shape. For example, to start in the middle of the shape, set the Phase to +180°.
Probability
See “Step Probability” on page 40.
Seq A/B/C/D
e four Seq Lanes generate modulation sources to control other synthesis parameters, just like envelopes, LFOs, etc.
Important: Motion Sequences run independently per voice. is means that the Step Seq Lane can only modulate per-
voice parameters, such as settings in the Amp, Pitch, Filter, Envelopes, and LFOs. Specically, the Step Seq Lane cannot
modulate the Mod Knobs, eects, or Kaoss Physics.
Step Seq Lane
Preset, Loop Start, Loop End, Loop Mode, Repeats, Note Advance
See “Standard Lane Controls” on page 39.
Use Shape
[O, On]
When this is On, non-zero values will be scaled by the Shape Lane.