Getting Started
16
Randomize
Randomize uses a combination of preset selection and select value randomization, rather than direct randomization of
all parameters.
To use Randomize:
1. Press the (Randomize) button at the top right of the window.
e Randomize dialog will appear.
2. Set the Scope as desired.
Scope controls the parts of the sound that will be randomized. It’s set to Performance by default, but can be set to
Program Select, Layer, Motion Sequence Select, Arpeggiator, Filter, and so on.
Depending on the Scope, additional settings may appear:
Fx/Mod Knob Values randomizes the Mod Knobs (Program and/or Performance, according to Scope) and Eects
Edit 1/2/3 by the specied percentage.
Modulation Intensities randomizes the standard LFO and Envelope intensities for Filter, Amp, Pitch, and Pan.
Randomize Fx Enables controls the On/O settings for the Eects (with probability weighted towards On).
Speed randomizes Motion Sequence Speed.
3. Press the Randomize button to randomize the selected Scope.
You can play the sound, and randomize repeatedly, without closing the Randomize window.
To Next Page
Loading...
Need help?
General
