Korg modwave native - Modulation List Page

Modulation List page
56
Modulation List page
1. Mod List
2. Show In
Mod List
3. Mod
Sources
is page gathers together all of the modulation sources and modulation routings into a single screen. You can even
edit the original values of the modulated parameters, along with all of the modulation settings.
For general information on using modulation, see “Modulation” on page 13.
1. Show in Mod List
is section lets you lter the Mod List to show only the routings that you’re interested in. ere are three sections,
ordered from top to bottom, each of which lters the next.
e top section lets you select All modulations, only modulations at the Performance level (such as modulation of Mod
Knobs, Master Reverb, or Kaoss Physics), or modulations for the currently selected Layer.
e middle section lters by either destination category (such as Synth or Eects) or source category (such as
Controllers or Generators).
e bottom section more specically, such as by specic synth section (such as the Filter) or a specic controller (such
as the Mod Wheel).
2. Mod List
is shows all of the modulation routings which match the criteria set in the Show in Mod List section. You can change
mod source selections, adjust modulation Intensities, delete modulation routings, and even edit the value of the
original parameter.
Note: built-in modulation routings, such as Filter Envelope modulation of Filter Cuto or Amp LFO modulation of
Level, are not shown here.
3. Mod Knobs
e Mod Knobs are available here, along with all of the other Mod Sources in the footer at the bottom of the window.
4: Layer Select
ese select which of the Layers is shown in Column 1 of the Show in Mod List section, as described above.