5–2: Amp 1 EG (Amplifier 1 EG)
46
For details on how Alternate Modulation and the other AMS functions operate, refer to page 157
“8. Appendix” in this manual and to page 33 “About alternate modulation” in the Basic Guide.
5–2c: Level Modulation
These settings affect the amp 1 EG levels that are set in “5–2a: Amplifier EG”.
Velocity
With positive (+) settings, volume levels will be raised as you play more strongly.
With negative (–) settings, volume levels will be lowered as you play more strongly.
With a setting of 0, the settings made in “5–2a: Amplifier” will be used.
St (Start Level) [–99…+99]
Adjusts the Start Level.
At (Attack Level) [–99…+99]
Adjusts the Attack Level.
Br (Break Point Level) [–99…+99]
Adjusts the Break Point Level.
▼ Page Menu Command
5–2A: Write Program
This command writes an edited program into the specified program number of the specified bank.
Be sure to write important programs. If you turn the power off or select a different program before
writing, the data cannot be recovered.
For details refer to Basic Guide page 23, “9. Writing a program or combination.”
5–2B: Copy Oscillator
This command copies the settings of oscillator 1 or 2 from the specified program to the oscillator of
the program being edited. You may also select a program from another bank as the copy source.
When copying Oscillator 2 to Oscillator 1, if Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1
LFO is selected for Oscillator 2 AMS, the settings will be automatically converted from Filter 1
EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to OSC LFO, and from Filter 1
LFO to Filter LFO.
5–2C: Swap Oscillator
This command exchanges the settings of oscillator 1 and 2 within the program being edited.
If an Oscillator 2 with AMS settings of Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1 LFO
is used for Oscillator 1 as a result of a Swap Oscillator command, the settings will be automat-
ically converted from Filter 1 EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to
OSC LFO, and from Filter 1 LFO to Filter LFO.
5–2D: Sync Both EGs (check command)
If this is checked, the Amp 1 EG and the Amp 2 EG will be edited simultaneously. (When you edit
one EG, the settings of the other EG will also change.)
Changes in volume (with all three at positive (+) settings)
Settings of 5–2a: Amplifier EG
Softly played note
Strongly played note
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
Volume
To Next Page
Loading...
Need help?
General
