17
Operating Instructions 10/2020 2010045v10
6.7 Authorization procedure
The following authorization procedures are supported by the charging station.
6.7.1 Free loading / no authorization
Charging does not require authorization. A charging process is started automatically after a plugged-in cable
is detected. The charging process is terminated by pressing the STOP button.
6.7.2 Free charging with RFID card
Charging requires any RFID card readable by the system for authorization. The charging process is
terminated by presenting the same RFID card in front of the card reader.
• Standard RFID cards or RFID systems
• Supports all NFC forum tags (type 1-4)
• NFC Peer to Peer Communication
• ISO 14443 A/B, Mifare, DESFire, ISO 18092 (NFC)
6.7.3 OCPP (online / offline)
Loading requires authorization. In the offline state, an RFID card is needed to match it with a whitelist or the
cache.
If there is an unintentional disconnection of the APN, the charging station switches internally and
automatically in this mode. After a successful reconnection, the charging station automatically switches back
to online mode. In online mode, the charging station can also be started by a remote command. It is
terminated by presenting the same RFID card, an RFID card from the same group or by a remote command
(online only).
For more information, see chapter "OCCP 7.2 (page 27)".
To Next Page
Loading...