38
Operating Instructions 10/2020 2010045v10
7.10 Time setting
In the configuration: "Time setting" enter the position and time zones of the charging station.
The time is generally synchronised via NTP. The connection via the maintenance router is used for this. By
default, the NTP server is reached at the address or reserve address as shown in the figure
"Parameterisation of the Siemens NTP server in the Scalance router".
The time display is shown after a restart only after the first successful synchronisation.
If you want to record the time zone via the position, you can enter the latitude and longitude. By pressing
"Retrieve time settings", this coordination is used to determine the correct time zone on the Internet. If
coordination is set here, the time zone settings are queried again at every restart, checked and possibly
adjusted.
The changeable offset for day/night switching is used as follows:
• Day mode = local time > sunrise - offset
• Night mode = local time > sunset + offset
You can adjust the time zone settings in the corresponding fields. Press "Apply time zone settings" to apply
the time zone settings. After a change, check the times in the "Act. Values
To Next Page
Loading...